petite astuce trouvée à l'instant sur le forum NAIM pour ceux qui veulent utiliser un Qute (par ex) en source et qui ont le pb de télécommande. monter ou baisser le son sur le pré, change aussi celui du Qute
Get the remote control as supplied with the Uniti Qute.
Turn the Qute off.
Switch it on.
As the startup banner shows press and hold the keys ‘aux, info and 5’ at the same time.
On the screen it will show a message ‘IR COMMS System Code 13’. From there on your Qute will be listening to different bank of IR codes and shouldn’t interact with the ones used by the preamp. If it doesn’t do it try again as there is a bit of an art to do it.
To put it back to normal do ‘aux, info and 1’.
This party trick can also be used to stop the devices clashing with other manufacturers products that use Philips RC5 as the remote control IR protocol. There are 6 alternative codes supported by pressing 1 to 6.
Hope that helps.
Steve Harris
Software Director
Naim Audio Ltd.